LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 350h >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Hybrid Transaxle System (P810) - Service Information >> Oil Pump >> Installation [11/2021 - 03/2024] >> Procedure

Installation [11/2021 - 03/2024]: Procedure

  1. INSTALL OIL PUMP WITH MOTOR ASSEMBLY 

    Torque: 46 N.m (469 kgf/cm, 34 ft.lbf) 

  2. INSTALL WIRE HARNESS CLAMP BRACKET 

    Torque: 20 N.m (204 kgf/cm, 15 ft.lbf) 

  3. CONNECT NO. 2 TRANSMISSION OIL COOLER HOSE ASSEMBLY 
    1. GTY1064605Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a 0 to 3 mm (0 to 0.118 in.) *b 2 to 7 mm (0.0787 to 0.276 in.)
      *c Paint Mark *d Marking
      *e Center of Paint Mark *f 45° (Claw of Clip Location)
      1. Connect the No. 2 transmission oil cooler hose assembly to the oil pump with motor assembly and slide the 2 clips to secure it.
        NOTE:
        • Make sure to slide the No. 2 transmission oil cooler hose assembly until it contacts the hose stopper of the oil pump with motor assembly.
        • Make sure to align the paint mark on each No. 2 transmission oil cooler hose assembly with each marking on the oil pump with motor assembly.
        • Make sure that the claws of the clip are within the location shown in the illustration.
  4. INSTALL INTAKE MANIFOLD 

    Refer to INSTALLATION [11/2021 - ]

  5. INSPECT HYBRID TRANSAXLE FLUID 

    See step  2

  6. INSPECT FOR HYBRID TRANSAXLE FLUID LEAK 
  7. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 67

  8. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 68

  9. INSTALL FRONT FENDER FRONT SPLASH SHIELD RH 
  10. INSTALL FRONT FENDER FRONT SPLASH SHIELD LH 
scientia non olet · About LEMON Manuals