DTC U0100-87: Lost Communication With ECM/PCM "A" Missing Message; DTC U0101-87: Lost Communication with TCM Missing Message; DTC U0103-87: Lost Communication with Gear Shift Control Module "A" Missing Message; DTC U0125-87: Lost Communication With Multi-axis Acceleration Sensor Module Missing Message; DTC U0126-87: Lost Communication with Steering Angle Sensor Module Missing Message; DTC U0131-87: Lost Communication With Power Steering Control Module Missing Message; DTC U0140-87: Lost Communication with Body Control Module Missing Message; DTC U0151-87: Lost Communication with Restraints Control Module Missing Message [11/2021 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2025 Lexus NX 350, 2025 Lexus NX 250, 2024 Lexus NX 350, 2024 Lexus NX 250, and 2023 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.
- CLEAR DTC
Pre-procedure1
- None
Procedure1
- Clear the DTCs.
Chassis > Brake/EPB > Clear DTCs
Result
Proceed to NEXT Post-procedure1
- Turn the ignition switch off.
Result:
NEXT
See step 2
- None
- CHECK DTC OUTPUT (HEALTH CHECK)
- Perform the Health Check using the GTS.
Result
Result Proceed to DTCs for related systems are output together with DTC U0100-87, U0101-87, U0103-87, U0125-87, U0126-87, U0131-87, U0140-87 or U0151-87. A U0100-87, U0101-87, U0103-87, U0125-87, U0126-87, U0131-87, U0140-87 or U0151-87 is output. B DTCs are not output. C
Result:
A
GO TO DIAGNOSTIC TROUBLE CODE CHART (RELATED SYSTEM)
Result:
B
INSPECT CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - ]
Result:
C
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - ]
- Perform the Health Check using the GTS.