LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 350h >> Repair and Diagnosis >> External Pages >> Different car >> Section 96 (Electronically Controlled Brake System - Diagnostic Codes (3 Of 3), Symptom Tests & Circuit Tests) >> ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model) >> DTC C1380-7F: Stop Lamp Relay Actuator Stuck Off [11/2021 - ] >> Description

DTC C1380-7F: Stop Lamp Relay Actuator Stuck Off [11/2021 - ]: Description

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2025 Lexus NX 350, 2025 Lexus NX 250, 2024 Lexus NX 350, 2024 Lexus NX 250, and 2023 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.

Refer to DTC C1380-7E.

Refer to DESCRIPTION 

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
C1380-7F Stop Lamp Relay Actuator Stuck Off When the voltage at the +BS terminal is between 10 V or more, the stop light drive output (STPO) is on, a signal is not input to the STP2 terminal for 5 seconds or more.
  • Wire harness or connector
  • Stop light switch assembly
  • Skid control ECU (brake actuator assembly)
  • Rear combination light assembly LH
  • Rear combination light assembly RH
  • Rear light assembly LH
  • Rear light assembly RH
  • Center stop light assembly
  • Semiconductor power integration ECU
 Brake/EPB B
scientia non olet · About LEMON Manuals