LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 350h >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Stop And Start System - Diagnostic Codes (1 Of 2)) >> Stop And Start System >> DTC P062F-44: Internal Control Module EEPROM Data Memory Failure [03/2024 - ] >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2025 Lexus NX 350, 2025 Lexus NX 250, 2024 Lexus NX 350, 2024 Lexus NX 250, and 2023 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.
ALL

Monitor runs whenever the following DTCs are not stored None
CASE 1

All of the following conditions are met -
Permanent Fault Code Not stored
OBDII system commands Store
Battery voltage 8 V or higher
CASE 2

All of the following conditions are met -
Permanent Fault Code Stored
OBDII system commands Clear
Battery voltage 8 V or higher
CASE 3

Battery voltage 8 V or higher
scientia non olet · About LEMON Manuals