DTC P062F-44: Internal Control Module EEPROM Data Memory Failure [03/2024 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2025 Lexus NX 350, 2025 Lexus NX 250, 2024 Lexus NX 350, 2024 Lexus NX 250, and 2023 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.
- CLEAR DTC
- Clear the DTCs.
Powertrain > Stop and Start > Clear DTCs
- Turn the ignition switch off.
Result
Proceed to NEXT
Result:
NEXT
See step 2
- Clear the DTCs.
- READ OUTPUT DTC (DTC P062F-44)
- Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
- Connect the cable to the negative (-) battery terminal.
- Start the engine and wait 30 seconds or more.
- Read the DTCs.
Powertrain > Stop and Start > Trouble Codes
Result
Result Proceed to DTCs are not output A DTC P062F-44 is output B
Result:
A
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - ]
Result:
B
REPLACE ENGINE STOP AND START ECU. Refer to REMOVAL [11/2021 - ]