Installation [11/2021 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus NX 350, 2024 Lexus NX 350, 2023 Lexus NX 350, and 2022 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY
*a Oil Inlet Port *b 3 Threads or More Adhesive Application Area - - - Apply adhesive to the area shown in the illustration.
Adhesive
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
NOTE:- Do not apply adhesive to the oil inlet port of the oil pressure sender gauge assembly.
- Apply the adhesive to the first 3 threads or more of the oil pressure sender gauge assembly.
- Apply adhesive to the entire circumference of the thread.
- Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.
Torque: 15 N.m (153 kgf/cm, 11 ft.lbf)
NOTE:Do not start the engine within 1 hour of installation.
- Connect the oil pressure sender gauge assembly connector.
- Apply adhesive to the area shown in the illustration.
- INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 6
- CHECK ENGINE OIL LEVEL
Refer to PROCEDURE - Step 1 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 1 [03/2024 - ]
- INSTALL FRONT FENDER APRON SEAL RH
Refer to PROCEDURE - Step 81 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 82 [03/2023 - ]