Installation [11/2021 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2025 Lexus NX 350, 2025 Lexus NX 250, 2024 Lexus NX 350, 2024 Lexus NX 250, and 2023 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL TRANSFER ASSEMBLY
*a 17 mm Union Nut Wrench *b Torque Wrench Fulcrum Length - Using SST and a 17 mm union nut wrench, install the transfer assembly to the automatic transaxle assembly with the 8 nuts.
- SST: 09961-00950
Specified Tightening Torque
Torque: 68.6 N.m (700 kgf/cm, 51 ft.lbf)
HINT:
- Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Refer to PRECAUTION [11/2021 - ]
- When using a 17 mm union nut wrench (fulcrum length of 30 mm (1.18 in.)) + SST (fulcrum length of 150 mm (5.91 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):
40.2 N.m (410 kgf/cm, 30 ft.lbf)
- Using SST and a 17 mm union nut wrench, install the transfer assembly to the automatic transaxle assembly with the 8 nuts.
- INSTALL REAR ENGINE MOUNTING BRACKET SUB-ASSEMBLY
- for UB80F:
Refer to PROCEDURE - Step 11 [11/2021 - 03/2022] , or refer to PROCEDURE - Step 11 [03/2022 - ]
- for UA81F:
Refer to PROCEDURE - Step 7 [11/2021 - 03/2022] , or refer to PROCEDURE - Step 7 [03/2022 - ]
- for UB80F:
- INSTALL REAR ENGINE MOUNTING INSULATOR
- for UB80F:
Refer to PROCEDURE - Step 12 [11/2021 - 03/2022] , or refer to PROCEDURE - Step 12 [03/2022 - ]
- for UA81F:
Refer to PROCEDURE - Step 2
- for UB80F:
- INSTALL PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY (for UA81F)
- INSTALL PROPELLER SHAFT HEAT INSULATOR (for UA81F)
- INSTALL AUTOMATIC TRANSAXLE ASSEMBLY
- for UB80F:
Refer to INSTALLATION [11/2021 - 03/2022] , or refer to INSTALLATION [03/2022 - ]
- for UA81F:
Refer to INSTALLATION [11/2021 - 03/2022] , or refer to INSTALLATION [03/2022 - ]
- for UB80F: