LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 350h >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Engine Lubrication System - Service Information) >> Engine Oil Cooler >> Installation [11/2021 - ] >> Procedure

Installation [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 250, 2024 Lexus NX 250, 2023 Lexus NX 250, and 2022 Lexus NX 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL OIL CONTROL VALVE FILTER (w/ Filter) 
  2. INSTALL OIL COOLER GASKET 
  3. INSTALL OIL COOLER ASSEMBLY 

    Torque: 16 N.m (163 kgf/cm, 12 ft.lbf) 

  4. CONNECT NO. 2 WATER BY-PASS HOSE 
  5. CONNECT NO. 1 WATER BY-PASS HOSE 
  6. ADD ENGINE OIL 

    Refer to PROCEDURE - Step 5 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 5 [03/2023 - ]

  7. ADD ENGINE COOLANT 

    Refer to PROCEDURE - Step 5

  8. INSPECT FOR ENGINE OIL LEAK 

    Refer to PROCEDURE - Step 6 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 6 [03/2023 - ]

  9. CHECK ENGINE OIL LEVEL 

    Refer to PROCEDURE - Step 1 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 1 [03/2024 - ]

  10. INSPECT FOR COOLANT LEAK 

    Refer to PROCEDURE - Step 1

  11. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 72

  12. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 73

  13. INSTALL FRONT FENDER FRONT SPLASH SHIELD LH 
  14. INSTALL FRONT FENDER FRONT SPLASH SHIELD RH 
scientia non olet · About LEMON Manuals