LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 350h >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Control System - Service Information) >> Manifold Absolute Pressure Sensor >> Removal [11/2021 - ] >> Procedure

Removal [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 350, 2024 Lexus NX 350, 2023 Lexus NX 350, and 2022 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY 
    Refer to PROCEDURE - Step 25 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 25 [03/2023 - 03/2024] , or refer to PROCEDURE - Step 25 [03/2024 - ]
  2. REMOVE NO. 1 TURBO PRESSURE SENSOR 
    1. GTY1076140Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the No. 1 turbo pressure sensor connector.
      2. Using an 8 mm socket wrench, remove the bolt and No. 1 turbo pressure sensor from the intake manifold.
        NOTE:

        If the No. 1 turbo pressure sensor has been struck or dropped, replace it.

  3. REMOVE NO. 2 TURBO PRESSURE SENSOR 
    1. GTY1076940Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the No. 2 turbo pressure sensor connector.
      2. Using an 8 mm socket wrench, remove the bolt and No. 2 turbo pressure sensor from the intercooler assembly.
        NOTE:

        If the No. 2 turbo pressure sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals