LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 350h >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Control System - Service Information) >> Manifold Absolute Pressure Sensor >> On-Vehicle Inspection [11/2021 - ] >> Procedure

On-Vehicle Inspection [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 350, 2024 Lexus NX 350, 2023 Lexus NX 350, and 2022 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT NO. 2 TURBO PRESSURE SENSOR 
    1. Check the terminal voltage.
      1. Disconnect the No. 2 turbo pressure sensor connector.
      2. Measure the voltage according to the value(s) in the table below.

        Standard Voltage

        Tester Connection Condition Specified Condition
        B72-3 (VC) - B72-2 (E2) Ignition switch ON 4.5 to 5.5 V
        B72-1 (PTA) - B72-2 (E2) 3.0 to 5.5 V

        If the result is not as specified, repair or replace the wire harness or connector.

        GTY1079072Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Front view of wire harness connector
        (to No. 2 Turbo Pressure Sensor)
    2. Check the turbo pressure.
      1. Turn the ignition switch to ON.
      2. According to the display on the GTS read the Data List.

        Powertrain > Engine > Data List 

        Tester Display
        Boost Pressure Sensor

        OK

        The value is approximately equal to atmospheric pressure.

        HINT: 

        • Standard atmospheric pressure is approximately 101 kPa (abs) (15 psi (abs)).
        • For every 100 m (328 ft) increase in altitude, atmospheric pressure drops by approximately 1 kPa (0.15 psi). This varies by weather.
scientia non olet · About LEMON Manuals