Installation [11/2021 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus NX 250, 2024 Lexus NX 250, 2023 Lexus NX 250, and 2022 Lexus NX 250. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL STAY
Torque: 6.0 N.m (61 kgf/cm, 53 in.lbf)
- INSTALL FRONT ENGINE MOUNTING INSULATOR
Torque: 72 N.m (734 kgf/cm, 53 ft.lbf)
- INSTALL FRONT ENGINE MOUNTING BRACKET
- Install the front engine mounting bracket to the transaxle housing with the 3 bolts.
Bolt (A), (B) and (C)
Torque: 42 N.m (428 kgf/cm, 31 ft.lbf)
NOTE:Temporarily tighten the bolt (A), and then fully tighten the 3 bolts in the order of (B), (C) and (A).
- Install the front engine mounting bracket to the front engine mounting insulator with the bolt.
Bolt (D)
Torque: 72 N.m (734 kgf/cm, 53 ft.lbf)
- Install the front engine mounting bracket to the transaxle housing with the 3 bolts.
- CONNECT VACUUM HOSE
- INSTALL NO. 1 RADIATOR BRACKET
Torque: 19 N.m (194 kgf/cm, 14 ft.lbf)
- INSTALL VACUUM SWITCHING VALVE (for Active Control Engine Mount System)
Refer to INSTALLATION [11/2021 - ]
- INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 72
- INSTALL NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 73
- INSTALL FRONT FENDER FRONT SPLASH SHIELD LH
- INSTALL FRONT FENDER FRONT SPLASH SHIELD RH