LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 350h >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Control System - Diagnostic Codes (P0110-P0136)) >> SFI System >> DTC P0128-00: Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature); DTC P0128-07: Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature) Mechanical Failure [11/2021 - 03/2022] >> Description

DTC P0128-00: Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature); DTC P0128-07: Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature) Mechanical Failure [11/2021 - 03/2022]: Description

WARNING: This page is about a different car, the 2025 Lexus NX 250, 2024 Lexus NX 250, 2023 Lexus NX 250, and 2022 Lexus NX 250. However, it is still accessible from the selected car via links, so may be relevant.

The ECM uses the engine coolant temperature sensor, installed to the water outlet, to monitor the operation of the thermostat.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note
P0128-00 Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature) All of the following conditions are met for 5 seconds or more (2 trip detection logic):
  1. Cold start.
  2. The engine is warmed up.
  3. The engine coolant temperature is less than 75°C (167°F).
  • Water inlet with thermostat sub-assembly
  • Engine cooling system
  • Engine coolant temperature sensor
  • ECM
Comes on SAE Code: P0128
P0128-07 Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature) Mechanical Failure All of the following conditions are met for 3 times (2 trip detection logic):
  1. The engine coolant temperature is less than 75°C (167°F).
  2. The value of the change in engine coolant temperature is less than the threshold.
  • Water inlet with thermostat sub-assembly
  • Engine cooling system
  • Engine coolant temperature sensor
  • Flow Shutting Valve (for Heater Control)
  • Flow Shutting Valve (for ATF Control)
  • ATF temperature sensor
  • ECM
Comes on SAE Code: P0128