DTC P0016-00: Crankshaft Position - Camshaft Position Correlation Bank 1 Sensor A [03/2022 - ]: Description

WARNING: This page is about a different car, the 2025 Lexus NX 250, 2024 Lexus NX 250, 2023 Lexus NX 250, and 2022 Lexus NX 250. However, it is still accessible from the selected car via links, so may be relevant.

Refer to DTC P0010-01.

Refer to DTC P0010-01: Camshaft Position "A" Actuator Bank 1 General Electrical Failure [03/2022 - ]

DTC No.	Detection Item	DTC Detection Condition	Trouble Area	MIL	Note
P0016-00	Crankshaft Position - Camshaft Position Correlation Bank 1 Sensor A	Deviation in the crankshaft position sensor signal and camshaft position sensor (for intake camshaft) signal (2 trip detection logic).	Valve timing Camshaft timing gear assembly ECM	Comes on	SAE Code: P0016 DTC for Mexico Models: Applies

HINT:

If initialization is performed using the GTS with any of the connectors of the wire harnesses between the power source or ECM and the cam timing control motor with EDU assembly disconnected, DTC P0016-00 may be stored. If DTC P0016-00 is output, check the connection condition of each connector.