DTC P0011-00: Camshaft Position "A" - Timing Over-Advanced or System Performance Bank 1 [11/2021 - 03/2022]: Procedure
WARNING: This page is about a different car, the 2025 Lexus NX 250, 2024 Lexus NX 250, 2023 Lexus NX 250, and 2022 Lexus NX 250. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0011-00)
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTC P0011-00 is output A DTC P0011-00 and other DTCs are output B HINT:
If any DTCs other than P0011-00 are output, troubleshoot those DTCs first.
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2021 - 03/2022]
Result:
A
See step 2
- Read the DTCs.
- REPLACE CAMSHAFT TIMING GEAR ASSEMBLY
Refer to PROCEDURE - Step 41
HINT:
Perform "Inspection After Repair" after replacing the camshaft timing gear assembly.
Refer to INITIALIZATION [11/2021 - ]
Result
Proceed to NEXT Result:
NEXT
See step 3
- CLEAR DTC
- Clear the DTCs.
Powertrain > Engine > Clear DTCs
- Turn the ignition switch off and wait for at least 30 seconds.
Result
Proceed to NEXT
Result:
NEXT
See step 4
- Clear the DTCs.
- CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
- Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTCs are not output A DTC P0011-00 is output B
Result:
A
END
Result:
B
REPLACE ECM. Refer to REMOVAL [11/2021 - ]