DTC P0010-01: Camshaft Position "A" Actuator Bank 1 General Electrical Failure [11/2021 - 03/2022]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 250, 2024 Lexus NX 250, 2023 Lexus NX 250, and 2022 Lexus NX 250. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT CAMSHAFT TIMING GEAR ASSEMBLY

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Camshaft Timing Gear Assembly
*2	Eccentric Shaft
*a	Spline

Remove the cam timing control motor with EDU assembly.
Refer to REMOVAL [11/2021 - ]

Check if the eccentric shaft of the camshaft timing gear assembly rotates smoothly.

NOTE:

If the camshaft is at a position where a valve is about to open, the eccentric shaft may become difficult to rotate.

Rotates smoothly.

HINT:

Perform "Inspection After Repair" after replacing the camshaft timing gear assembly, or removing or replacing the cam timing control motor with EDU assembly.

Refer to INITIALIZATION [11/2021 - ]

Result

Proceed to
OK
NG

Result:

REPLACE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY. Refer to REMOVAL [11/2021 - ]

Result:

REPLACE CAMSHAFT TIMING GEAR ASSEMBLY. Refer to PROCEDURE - Step 41