Removal [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 350, 2024 Lexus NX 350, 2023 Lexus NX 350, and 2022 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.

PRECAUTION

NOTE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Refer to BEFORE DISCONNECTING BATTERY [11/2021 - ]

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 2
REMOVE FRONT FENDER FRONT SPLASH SHIELD LH
Refer to PROCEDURE - Step 8 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 8 [03/2023 - 03/2024] , or refer to PROCEDURE - Step 8 [03/2024 - ]
REMOVE FRONT FENDER FRONT SPLASH SHIELD RH
Refer to PROCEDURE - Step 9 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 9 [03/2023 - 03/2024] , or refer to PROCEDURE - Step 9 [03/2024 - ]
REMOVE NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 10 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 10 [03/2023 - 03/2024] , or refer to PROCEDURE - Step 10 [03/2024 - ]
DRAIN COOLANT (for Intercooler)
Refer to PROCEDURE - Step 4
REMOVE V-RIBBED BELT
Refer to REMOVAL [11/2021 - ]

DISCONNECT NO. 2 INTERCOOLER COOLING WATER HOSE

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

DISCONNECT NO. 3 INTERCOOLER COOLING WATER HOSE

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE INTERCOOLER RESERVE TANK ASSEMBLY

DISCONNECT ENGINE WIRE

REMOVE GENERATOR ASSEMBLY

Remove the 2 nuts and bolt.
Using an E8 "TORX" socket wrench, remove the stud bolt and generator assembly.