Odo/Trip Switch Malfunction [11/2021 - ]: Procedure

1. Perform the Active Test according to the display on the GTS.

   Body Electrical > Combination Meter > Active Test 

   Tester Display	Measurement Item	Control Range	Diagnostic Note
   ODO/TRIP Change Switch	Performs the same operation as pressing the ODO/TRIP switch	OFF/ON	-

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   ODO/TRIP Change Switch

   Result

   Result	Proceed to
   Active Test can be performed correctly	A
   Active Test cannot be performed correctly	B

Result: 

B 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [11/2021 - ] 

Result: 

A 

See step  2

1. Read the Data List according to the display on the GTS.

   Body Electrical > Combination Meter > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   ODO/TRIP Change Switch	ODO/TRIP switch operation	OFF or ON	OFF: Switch released ON: Switch pushed	-

   Body Electrical > Combination Meter > Data List 

   Tester Display
   ODO/TRIP Change Switch

   Result

   Result	Proceed to
   The value of the Data List item is correct, and the combination meter assembly operates correctly	A
   The value of the Data List item is correct, but the combination meter assembly does not operate correctly	B
   The Data List item changes correctly	C

Result: 

A 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - ] 

Result: 

B 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [11/2021 - ] 

Result: 

C 

See step  3

Refer to INSPECTION [11/2021 - ]

Result

Result: 

NG 

REPLACE TRIP SWITCH. Refer to  REMOVAL [11/2021 - ] 

Result: 

OK 

See step  4

1. Disconnect the D22 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D81-4 (A/B) - D22-13 (ODO)	Always	Below 1 Ω
   D81-7 (E) - D22-26 (SW3)	Always	Below 1 Ω
   D81-4 (A/B) or D22-13 (ODO) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [11/2021 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR