Caution / Notice / Hint

NOTE:

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
When replacing the combination meter assembly, update the ECU security key.
Refer to UPDATE ECU SECURITY KEY [11/2021 - ]
Before preforming this procedure, check for Meter / Gauge System DTC B1500-13 or B1501-13* which is stored if an open or short in the circuit is detected. If DTC B1500-13 or B1501-13* is output, perform troubleshooting and repairs as necessary.
Refer to DTC B1500-13: Fuel Sender Circuit Open; DTC B1501-13: Sub Fuel Sender Circuit Open [11/2021 - ]
1. *: for Gasoline Model
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Refer to BEFORE DISCONNECTING BATTERY [11/2021 - ]
To prevent the key from being locked in the vehicle, make sure to enter e-latch inspection mode and enable the manual release handle before disconnecting the cable from the negative (-) auxiliary battery terminal.
Refer to INSPECTION MODE PROCEDURE [11/2021 - ]