LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 350h >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Door / Hatch - Service Information (2 Of 2) >> Power Back Door Drive Unit >> Removal [11/2021 - ] >> Procedure

Removal [11/2021 - ]: Procedure

  1. REMOVE BACK DOOR UPPER TRIM COVER 

    See step  1

  2. REMOVE BACK DOOR SIDE GARNISH LH 

    See step  2

  3. REMOVE BACK DOOR SIDE GARNISH RH 
    1. Use the same procedure for the LH side.
  4. REMOVE BACK DOOR LOCK COVER 
    See step  5
  5. REMOVE BACK DOOR INSIDE HANDLE 
    See step  6
  6. REMOVE SWITCH BASE 
    See step  7
  7. REMOVE BACK DOOR SERVICE HOLE COVER 

    See step  8

  8. REMOVE BACK DOOR TRIM BOARD ASSEMBLY 

    See step  9

  9. REMOVE POWER BACK DOOR SENSOR ASSEMBLY 

    See step  9

  10. REMOVE POWER BACK DOOR UNIT SET ASSEMBLY 
    1. GTY1052736Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Grommet - -
      Remove in this Direction - -
      1. Disconnect the connector.
      2. Disengage the grommet as shown in the illustration.
      3. Using a screwdriver with its tip wrapped with protective tape, slightly raise the 2 stop rings as shown in the illustration.
      4. Disengage the 2 ball joints to remove the power back door unit set assembly.
        NOTE:
        • Remove the power back door unit set assembly while supporting the back door by hand.
        • Make sure to replace the power back door unit set assembly with a new one.
  11. REMOVE BACK DOOR DAMPER STAY UPPER BRACKET 
    1. GTY1053895Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  12. REMOVE BACK DOOR DAMPER STAY LOWER BRACKET 
    1. GTY1053112Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  13. REMOVE BACK DOOR STAY STOPPER 
    1. GTY1054579Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals