LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 350 Base >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System - Service Information >> Oil Pressure Sensor >> Removal [11/2021 - ] >> Procedure

Removal [11/2021 - ]: Procedure

  1. REMOVE FRONT FENDER APRON SEAL RH 

    Refer to PROCEDURE - Step 13 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 13 [03/2023 - 03/2024] , or refer to PROCEDURE - Step 13 [03/2024 - ]

  2. REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY 
    1. GTY1074863Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the oil pressure sender gauge assembly connector.
      2. Using a 27 mm deep socket wrench, remove the oil pressure sender gauge assembly.
        NOTE:

        If the oil pressure sender gauge assembly is dropped or subjected to a strong impact, replace it with a new one.

scientia non olet · About LEMON Manuals