LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 350 Base >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System (Hydraulic) - Service Information >> VACUUM PUMP (for T24A-FTS) >> Removal [03/2023 - ] >> Procedure

Removal [03/2023 - ]: Procedure

  1. REMOVE BATTERY 

    Refer to REMOVAL [11/2021 - ]

  2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY 
    Refer to PROCEDURE - Step 25 [03/2023 - 03/2024] , or refer to PROCEDURE - Step 25 [03/2024 - ]
  3. REMOVE NO. 3 ENGINE COVER 

    Refer to PROCEDURE - Step 26 [03/2023 - 03/2024] , or refer to PROCEDURE - Step 26 [03/2024 - ]

  4. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 16

  5. REMOVE VACUUM REGULATING VALVE ASSEMBLY 
    1. GTY1067416Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE COMPRESSOR INLET ELBOW SUB-ASSEMBLY 
    Refer to PROCEDURE - Step 18
  7. DISCONNECT NO. 1 VACUUM HOSE CONNECTOR 
    1. GTY1063709Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape *b Retainer
      Pull off - -
      1. Using a screwdriver with its tip wrapped with protective tape, pull out the retainer as shown in the illustration.
      2. Pull off the No. 1 vacuum hose connector.
  8. REMOVE VACUUM PUMP ASSEMBLY 
    1. GTY1063910Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE NO. 1 VACUUM PUMP O-RING 
    1. GTY1063891Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals