Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during meter mirror sub-assembly removal/installation are shown below.
NOTE:
- After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
- To prevent the key from being locked in the vehicle, make sure to enter e-latch inspection mode and enable the manual release handle before disconnecting the cable from the negative (-) auxiliary battery terminal.
HINT:
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- for HEV Model:LEARNING COMPLETES WHEN VEHICLE IS DRIVEN
Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link Lighting System (EXT) Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. Refer to INITIALIZATION [11/2021 - ] Front Camera System Adaptive High Beam System LEARNING COMPLETES WHEN VEHICLE IS OPERATED NORMALLYEffect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link E-latch System - Back door opener
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. Refer to INITIALIZATION [11/2021 - ] Power Back Door System Reset back door close position Refer to INITIALIZATION [11/2021 - ] Air Conditioning System After the ignition switch is turned to ON, the servo motor standard position is recognized. - - for Gasoline Model:LEARNING COMPLETES WHEN VEHICLE IS DRIVEN
Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link Lighting System (EXT) Drive the vehicle straight ahead at 15 km/h (10 mph) or more for 1 second or more. Refer to INITIALIZATION [11/2021 - ] Front Camera System Adaptive High Beam System Stop and Start System Idle the engine for approximately 5 to 60 minutes or drive the vehicle until stop and start control is permitted. Refer to PRECAUTION [11/2021 - 03/2023] , or refer to PRECAUTION [03/2023 - 03/2024] , or refer to PRECAUTION [03/2024 - ] LEARNING COMPLETES WHEN VEHICLE IS OPERATED NORMALLYEffect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link E-latch System - Back door opener
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. Refer to INITIALIZATION [11/2021 - ] Power Back Door System Reset back door close position Refer to INITIALIZATION [11/2021 - ] Air Conditioning System After the ignition switch is turned to ON, the servo motor standard position is recognized. -
WARNING:
Be sure to read Precaution thoroughly before servicing.
Refer to PRECAUTION [11/2021 - ]