Installation [11/2021 - ]: Procedure
- INSTALL SPARK PLUG NOTE:
If a spark plug has been struck or dropped, replace it.
Torque: 20 N.m (204 kgf/cm, 15 ft.lbf)
- INSTALL IGNITION COIL ASSEMBLY
Refer to PROCEDURE - Step 2 - INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 47 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 43 [03/2024 - ] - PERFORM INITIALIZATION
- Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.
Refer to INITIALIZATION [11/2021 - ]
- Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.