LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case System - Service Information) >> Transfer Assembly >> Installation [11/2021 - ] >> Procedure

Installation [11/2021 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL TRANSFER ASSEMBLY 
    1. GTY1063474Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a 17 mm Union Nut Wrench *b Torque Wrench Fulcrum Length
      1. Using SST and a 17 mm union nut wrench, install the transfer assembly to the automatic transaxle assembly with the 8 nuts.
        • SST: 09961-00950 

        Specified Tightening Torque 

        Torque: 68.6 N.m (700 kgf/cm, 51 ft.lbf) 

        HINT: 

        • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

          Refer to PRECAUTION [11/2021 - ]

        • When using a 17 mm union nut wrench (fulcrum length of 30 mm (1.18 in.)) + SST (fulcrum length of 150 mm (5.91 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):

          40.2 N.m (410 kgf/cm, 30 ft.lbf)

  2. INSTALL REAR ENGINE MOUNTING BRACKET SUB-ASSEMBLY 
  3. INSTALL REAR ENGINE MOUNTING INSULATOR 
  4. INSTALL PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY (for UA81F) 
    1. Fig 1: Propeller Shaft Heat Insulator Bracket Sub-Assembly Bolts Tightening Sequence
      GTY1065128Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Temporarily Tighten - -
      1. Install the propeller shaft heat insulator bracket sub-assembly to the transfer assembly with the 2 bolts in the order shown in the illustration.

        Torque: 25 N.m (255 kgf/cm, 18 ft.lbf) 

  5. INSTALL PROPELLER SHAFT HEAT INSULATOR (for UA81F) 
    1. Fig 2: Propeller Shaft Heat Insulator Bolts Tightening Sequence
      GTY1065649Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Temporarily Tighten - -
      1. Install the propeller shaft heat insulator with the 3 bolts in the order shown in the illustration.

        Torque: 18 N.m (184 kgf/cm, 13 ft.lbf) 

  6. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY 
scientia non olet · About LEMON Manuals