Installation [03/2024 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSTALL 4WD ECU ASSEMBLY
*a 10.7 mm (0.421 in.) or higher - - - Temporarily install the 4WD ECU assembly to the vehicle body with the 2 nuts.
- Confirm that two-thirds or more of the diameter of the nut (A) is overlapping the vehicle body, and fully tighten the nuts in the order of (A) then (B).
Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf)
- Engage the clamp.
- Connect the 2 4WD ECU assembly connectors.
- INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
Refer to PROCEDURE - Step 23 - INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
- INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY
- INSTALL ROPE HOOK ASSEMBLY
Refer to PROCEDURE - Step 27
- INSTALL REAR SEAT SIDE GARNISH LH
- INSTALL NO. 1 SIDE TRIM BASE COVER LH
- CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
- INSTALL REAR FLOOR FINISH PLATE
- INSTALL REAR DOOR SCUFF PLATE LH
- INSTALL DECK FLOOR BOX LH
- INSTALL DECK FLOOR BOX RH
- INSTALL REAR FLOOR BOARD REAR LH
- INSTALL REAR FLOOR BOARD REAR RH
- INSTALL REAR DECK FLOOR BOX (w/o Spare Tire)
- INSTALL REAR SEAT ASSEMBLY
- for Manual Seat:
Refer to INSTALLATION [11/2021 - ]
- for Power Seat:
Refer to INSTALLATION [11/2021 - ]
- for Manual Seat:
- INSTALL DECK BOARD ASSEMBLY
- INSTALL TONNEAU COVER ASSEMBLY
- OPERATION WHEN REPLACING ECU (for T24A-FTS) NOTE:
When the 4WD ECU assembly is replaced, it is necessary to perform the following in order: ECU Configuration and ECU Data Write.
Refer to CALIBRATION [03/2023 - ]