Caution / Notice / Hint
WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- When using the GTS with the ignition switch off, perform lock and unlock operations using the door control switch of the multiplex network master switch assembly at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins, and then select the vehicle model manually.
Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Smart Access. While using the GTS, periodically perform lock and unlock operations using the door control switch of the multiplex network master switch assembly at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
- The smart access system with push-button start (for Entry Function) uses the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the smart access system with push-button start (for Entry Function) after confirming that the communication systems are functioning properly.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - 03/2023] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [03/2023 - ]
- Before replacing the certification ECU (smart key ECU assembly), refer to Precaution.
Refer to PRECAUTION [11/2021 - 03/2023] , or refer to PRECAUTION [03/2023 - ]
- After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".