LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (Engine Control System - Diagnostic Codes (P0069-P0110)) >> SFI System >> DTC P0100-64: Mass or Volume Air Flow Sensor "A" Signal Plausibility Failure [03/2023 - 03/2024] >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
All of the following conditions are met -
Throttle position voltage 0.2 V or higher, and less than 2 V
Time after engine start 5 seconds or more
Auxiliary battery voltage 10.5 V or higher
Engine coolant temperature 70°C (158°F) or higher
Estimated load 30% or higher, and less than 70%
Mass air flow meter circuit fail (P0102, P0103) Not detected
Intake air temperature sensor circuit fail (P0112, P0113) Not detected
Engine coolant temperature sensor circuit fail (P0117, P0118) Not detected
Crankshaft position sensor circuit fail (P0335, P0337, P0338) Not detected
Throttle position sensor circuit fail (P0121, P0122, P0123, P0222, P0223, P2135) Not detected
Canister pressure sensor circuit fail (P0452, P0453) Not detected
Leak detection pump fail (P2401, P2402) Not detected
Evap system vent valve fail (P2419, P2420) Not detected