LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (Engine Control System - Diagnostic Codes (P0069-P0110)) >> SFI System >> DTC P0100-64: Mass or Volume Air Flow Sensor "A" Signal Plausibility Failure [03/2022 - 03/2023] >> Description

DTC P0100-64: Mass or Volume Air Flow Sensor "A" Signal Plausibility Failure [03/2022 - 03/2023]: Description

WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.

Refer to DTC P0100-12.

Refer to DTC P0100-12: Mass or Volume Air Flow Sensor "A" Circuit Short to Battery; DTC P0100-14: Mass or Volume Air Flow Sensor "A" Circuit Short to Ground or Open [03/2022 - 03/2023] 

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note
P0100-64 Mass or Volume Air Flow Sensor "A" Signal Plausibility Failure All of the following conditions are met (2 trip detection logic).
  1. The engine is running.
  2. The engine coolant temperature is 70°C (158°F) or higher.
  3. The throttle position sensor voltage is 0.2 V or higher, and less than 2 V.
  4. Average engine load value ratio is less than 0.85, or higher than 1.2 (varies with estimated engine load).

    Average engine load value ratio = Average engine load based on mass air flow meter sub-assembly output / Average engine load estimated from driving conditions

  5. Average air fuel ratio is less than -5%, or higher than 20%.
  • Mass air flow meter sub-assembly
  • Intake system
  • PCV hose connections
  • EGR valve assembly
Comes on
  • SAE Code: P0101
  • DTC for Mexico Models: Does not apply