LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Engine Control System - Service Information) >> AIR FUEL RATIO SENSOR (for Sensor 1) >> Removal [11/2021 - ] >> Procedure

Removal [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY 
    Refer to PROCEDURE - Step 19 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 19 [03/2024 - ]
  2. REMOVE AIR FUEL RATIO SENSOR 
    1. GTY1077091Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disengage the 3 wire harness clamps.
      2. Disconnect the air fuel ratio sensor connector.
      3. Using SST, remove the air fuel ratio sensor from the exhaust manifold.
        • SST: 09224-00012 
        NOTE:

        If the air fuel ratio sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals