LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Fuel System - Service Information) >> Fuel Pump Ecu >> Removal [11/2021 - ] >> Procedure

Removal [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE TONNEAU COVER ASSEMBLY 

    Refer to PROCEDURE - Step 1

  2. REMOVE DECK BOARD ASSEMBLY 

    Refer to PROCEDURE - Step 2

  3. REMOVE REAR SEAT ASSEMBLY 
    1. for Manual Seat:

      Refer to REMOVAL [11/2021 - ]

    2. for Power Seat:

      Refer to REMOVAL [11/2021 - ]

  4. REMOVE REAR DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 21

  5. REMOVE NO. 3 BATTERY SERVICE COVER BOARD 

    Refer to PROCEDURE - Step 23

  6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP 

    Refer to PROCEDURE - Step 22

  7. REMOVE NO. 1 SIDE TRIM BASE COVER LH 

    Refer to PROCEDURE - Step 35

  8. REMOVE REAR SEAT SIDE GARNISH LH 

    Refer to PROCEDURE - Step 37

  9. REMOVE FUEL PUMP CONTROL ECU 
    1. GTY1075765Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the 2 fuel pump control ECU connectors.
      2. Remove the bolt and fuel pump control ECU from the vehicle body.
        NOTE:

        Do not reuse the fuel pump control ECU if it has been dropped or subjected to a severe impact.

  10. REMOVE FUEL PUMP CONTROL ECU BRACKET 
    1. GTY1075368Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals