LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Engine Control System - Service Information) >> Manifold Absolute Pressure Sensor >> Installation [11/2021 - ] >> Procedure

Installation [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 350, 2024 Lexus NX 350, 2023 Lexus NX 350, and 2022 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL NO. 2 TURBO PRESSURE SENSOR 
    1. GTY1077816Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Using an 8 mm socket wrench, install the No. 2 turbo pressure sensor to the intercooler assembly with the bolt.

        Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

        NOTE:

        If the No. 2 turbo pressure sensor has been struck or dropped, replace it.

      2. Connect the No. 2 turbo pressure sensor connector.
  2. INSTALL NO. 1 TURBO PRESSURE SENSOR 
    1. GTY1078278Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Using an 8 mm socket wrench, install the No. 1 turbo pressure sensor to the intake manifold with the bolt.

        Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

        NOTE:

        If the No. 1 turbo pressure sensor has been struck or dropped, replace it.

      2. Connect the No. 1 turbo pressure sensor connector.
  3. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY 
    Refer to PROCEDURE - Step 54 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 55 [03/2023 - ]
scientia non olet · About LEMON Manuals