LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Engine Lubrication System - Service Information) >> Oil Pressure Sensor >> Removal [11/2021 - ] >> Procedure

Removal [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 350, 2024 Lexus NX 350, 2023 Lexus NX 350, and 2022 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT FENDER APRON SEAL RH 

    Refer to PROCEDURE - Step 13 [11/2021 - 03/2023] , or refer to PROCEDURE - Step 13 [03/2023 - 03/2024] , or refer to PROCEDURE - Step 13 [03/2024 - ]

  2. REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY 
    1. GTY1074863Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the oil pressure sender gauge assembly connector.
      2. Using a 27 mm deep socket wrench, remove the oil pressure sender gauge assembly.
        NOTE:

        If the oil pressure sender gauge assembly is dropped or subjected to a strong impact, replace it with a new one.

scientia non olet · About LEMON Manuals