Caution / Notice / Hint

WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during water inlet with thermostat sub-assembly removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Replacement of throttle body with motor assembly Cleaning the deposits from the throttle body with motor assembly Replacement of EGR valve assembly Gas leak from exhaust system is repaired	Perform Inspection After Repair	Poor idle, etc. Engine start function, etc.	Refer to INITIALIZATION [11/2021 - ]

NOTE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Refer to PRECAUTION [11/2021 - ]

COMPONENTS (REMOVAL)

Fig 1: Thermostat Removal Components (1 Of 2)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Callout - Procedure		Part Name Code
1	FRONT FENDER FRONT SPLASH SHIELD LH	53896B	-	-	-
2	FRONT FENDER FRONT SPLASH SHIELD RH	53895B	-	-	-
3	NO. 1 ENGINE UNDER COVER	51441	-	-	-
4	DRAIN ENGINE COOLANT (for Engine)	-	-	See step 4	-

Fig 2: Thermostat Removal Components (2 Of 2)

Callout - Procedure		Part Name Code
5	INTAKE MANIFOLD	17111	-	-	-
6	NO. 2 RADIATOR HOSE	16572D	-	-	-
7	NO. 7 WATER BY-PASS HOSE	16295	See step 7	-	-
8	WATER INLET WITH THERMOSTAT SUB-ASSEMBLY	16031	See step 8	-	-

*A	for Type A	*B	for Type B
*1	GASKET	-	-
•	Non-reusable part	-	-