LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Hybrid Control System - Diagnostics - Introduction (1 Of 2)) >> Hybrid Control System >> Check For Intermittent Problems [11/2021 - ] >> Check For Intermittent Problems [11/2021 - ]

Check For Intermittent Problems [11/2021 - ]

WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR INTERMITTENT PROBLEMS 
    1. Perform a simulation test.

      Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - ]

      1. For the simulation test, reproduce the driving conditions that were present when the problem occurred. These conditions should be based on the customer's comments and Freeze Frame Data that is recorded with DTCs, such as the opening angle of the accelerator pedal, SOC (state of charge), engine coolant temperature, engine speed, and generator (MG1) / front motor (MG2) / rear motor (MGR) rpm and torque.
    2. Check the connector(s) and terminal(s).

      Refer to ELECTRONIC CIRCUIT INSPECTION PROCEDURE [11/2021 - ]

    3. Wiggle the harness and connector(s).

      Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - ]

    4. Heat or cool suspected parts.

      Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - ]