DTC P0125-00: Insufficient Coolant Temperature for Closed Loop Fuel Control [03/2024 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION DTC P0125-00)
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTC P0125-00 is output A DTC P0125-00 and other DTCs are output B HINT:
If any DTCs other than P0125-00 are output, troubleshoot those DTCs first.
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [03/2024 - ]
Result:
A
See step 2
- Read the DTCs.
- INSPECT WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
Refer to INSPECTION [11/2021 - ]
Result
Proceed to OK NG Result:
NG
REPLACE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY. Refer to REMOVAL [11/2021 - ]
Result:
OK
See step 3
- CHECK ENGINE COOLING SYSTEM
- Check for defects in the engine cooling system that might cause the system to be too cold, such as abnormal cooling fan operation or any modifications.
HINT:
Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Refer to INITIALIZATION [11/2021 - ]
Result
Proceed to OK NG
Result:
OK
REPLACE ENGINE COOLANT TEMPERATURE SENSOR. Refer to REMOVAL [11/2021 - ]
Result:
NG
REPAIR OR REPLACE ENGINE COOLING SYSTEM
- Check for defects in the engine cooling system that might cause the system to be too cold, such as abnormal cooling fan operation or any modifications.