LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 250 FWD >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System - Service Information >> Oil Pressure And Temperature Sensor >> Removal [11/2021 - ] >> Procedure

Removal [11/2021 - ]: Procedure

  1. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY 

    See step  1

  2. REMOVE OIL PRESSURE AND TEMPERATURE SENSOR 
    1. GTY1075569Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the oil pressure and temperature sensor connector.
      2. Using a 24 mm deep socket wrench, remove the oil pressure and temperature sensor.
        NOTE:

        If the oil pressure and temperature sensor is dropped or subjected to a strong impact, replace it with a new one.

scientia non olet · About LEMON Manuals