Removal [11/2021 - ]: Procedure

REMOVE BATTERY
Refer to REMOVAL [11/2021 - ]
REMOVE ECM
Refer to REMOVAL [11/2021 - ]
REMOVE BATTERY CLAMP SUB-ASSEMBLY
Refer to PROCEDURE - Step 29 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 29 [03/2024 - ]
REMOVE FRONT WHEEL LH
Refer to REMOVAL [11/2021 - 03/2024] , or refer to REMOVAL [03/2024 - ]
REMOVE FRONT FENDER FRONT SPLASH SHIELD RH
Refer to PROCEDURE - Step 9 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 9 [03/2024 - ]
REMOVE FRONT FENDER FRONT SPLASH SHIELD LH
Refer to PROCEDURE - Step 8 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 8 [03/2024 - ]
REMOVE NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 10 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 10 [03/2024 - ]
REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 11 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 11 [03/2024 - ]
REMOVE FRONT FENDER APRON SEAL LH
Refer to PROCEDURE - Step 12 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 12 [03/2024 - ]
DRAIN ENGINE COOLANT
Refer to PROCEDURE - Step 4

REMOVE FLOW SHUTTING VALVE (NO. 1 WATER BY-PASS HOSE)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Slide the clip and disconnect the flow shutting valve (No. 1 water by-pass hose) from the water outlet.
HINT:

Use a container to catch any engine coolant which flows out of the flow shutting valve (No. 1 water by-pass hose) and water outlet.
Slide the clip and disconnect the flow shutting valve (No. 1 water by-pass hose) from the transmission oil cooler.
HINT:

Use a container to catch any engine coolant which flows out of the flow shutting valve (No. 1 water by-pass hose) and transmission oil cooler.