Installation [12/2023 - ]: Procedure

INSTALL AUXILIARY BATTERY
INSTALL BATTERY CLAMP SUB-ASSEMBLY
Bolt

Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf)

Nut

Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf)

INSTALL BATTERY HOSE

NOTE:

After replacing the auxiliary battery, install the ventilation hole plug supplied with the new auxiliary battery or the ventilation hole plug from the old auxiliary battery to the ventilation hole on the side to which the battery hose is not connected.

HINT:

Push the battery hose onto the auxiliary battery until a click sound is heard.
Do not twist the battery hose.

CONNECT CABLE TO POSITIVE AUXILIARY BATTERY TERMINAL
Torque: 5.0 N.m (51 kgf/cm, 44 in.lbf)
INSTALL NO. 2 CONVERTER COOLING INTAKE DUCT
INSTALL DECK FLOOR BOX RH
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf)
INSTALL BATTERY SERVICE HOLE COVER
INSTALL DECK BOARD ASSEMBLY
INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Refer to WORK PROCEDURE [09/2023 - ]

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Refer to AUTOMATIC LEARNING CHART [09/2023 - ]