Replacement [09/2023 - ]: Procedure

REPLACE HYBRID TRANSAXLE FLUID

Lift the vehicle.
NOTE:
Set the vehicle on a lift so that the vehicle is kept level when it is lifted up (make sure that the tilt angle from the front to rear of the vehicle is within +/- 1°).

Remove the filler plug and gasket from the rear transaxle with motor and inverter assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a 10 mm hexagon socket wrench, remove the drain plug and gasket from the rear transaxle with motor and inverter assembly and drain the hybrid transaxle fluid.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a 10 mm hexagon socket wrench, install the drain plug and a new gasket to the rear transaxle with motor and inverter assembly.
Torque: 50 N.m (510 kgf/cm, 37 ft.lbf)

Add hybrid transaxle fluid until the hybrid transaxle fluid level is between 0 to 7 mm (0 to 0.276 in.) from the bottom lip of the filler plug opening. [#]

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Filler Nozzle
*b	0 to 7 mm (0 to 0.276 in.)

Hybrid Transaxle Fluid Standard Capacity (for Reference)

3.1 liters (3.3 US qts, 2.7 Imp. qts)

NOTE:

Use Toyota Genuine e-Transaxle Fluid TE.
Using hybrid transaxle fluid other than the above type may cause abnormal noise or vibration, or ultimately damage the transaxle of the vehicle.
Be sure to fully insert the filler nozzle into the filler plug opening.
Be sure to add hybrid transaxle fluid slowly. If hybrid transaxle fluid is added quickly, the hybrid transaxle fluid may hit internal parts and bounce back, resulting in hybrid transaxle fluid coming out of the filler plug opening.
Be sure to directly check that the hybrid transaxle fluid level is within the specified range.
Driving the vehicle with an insufficient or excessive amount of hybrid transaxle fluid may damage the rear transaxle with motor and inverter assembly.

After adding hybrid transaxle fluid, leave the vehicle for 30 seconds so that the hybrid transaxle fluid surface can become still again, and then check that the hybrid transaxle fluid level is between 0 to 7 mm (0 to 0.276 in.) from the bottom lip of the filler plug opening. (If the hybrid transaxle fluid level is low, repeat this procedure from step [#].)
NOTE:
After adding hybrid transaxle fluid, make sure to check the hybrid transaxle fluid level.

Refer to PROCEDURE - Step 1
Install the filler plug and a new gasket to the rear transaxle with motor and inverter assembly.
Torque: 50 N.m (510 kgf/cm, 37 ft.lbf)
Check for hybrid transaxle fluid leaks.
Lower the vehicle.