LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> TX 350 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Hybrid Transaxle System (Pc60) - Diagnostic Codes (4 Of 4) & Circuit Tests) >> Hybrid Transaxle System >> DTC P281B-49: Pressure Control Solenoid "H" Control Internal Electronic Failure [09/2023 - ] >> Procedure

DTC P281B-49: Pressure Control Solenoid "H" Control Internal Electronic Failure [09/2023 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus TX 500h. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P281B-49) 
    1. Read the DTCs using the GTS.

      Powertrain > Transmission > Trouble Codes 

      Result

      Result Proceed to
      Only P281B-49 is output A
      P281B-49 and other DTCs are output B

      HINT: 

      If any DTCs other than DTC P281B-49 are output, perform troubleshooting for those DTCs first.

    Result: 

    GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [09/2023 - ] 

    Result: 

    See step  2

  2. INSPECT TRANSMISSION WIRE (SOLENOID (SL5) VALVE) 

    Pre-procedure1

    • Disconnect the transmission wire connector.
    • Measure the resistance according to the value(s) in the table below.
      GTY1230534Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Transmission Wire)

      Standard Resistance

      Tester Connection Condition Specified Condition Result
      C65-30 (SL5+) - C65-9 (SLG2) 20°C (68°F) 5.0 to 5.6 Ω Ω

      Result

      Proceed to
      OK
      NG

    Post-procedure1

    • None.

    Result: 

    OK 

    REPLACE TCM. Refer to  REMOVAL [09/2023 - ] 

    Result: 

    NG 

    REPLACE TRANSMISSION VALVE BODY ASSEMBLY. Refer to  REMOVAL [09/2023 - ]