Starter System [09/2023 - ]: Procedure

1. Check if the engine can be cranked.

   Result

   Result	Proceed to
   Engine cannot be cranked	A
   Engine can be cranked	B

Result: 

B 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [09/2023 - ] 

Result: 

A 

See step  2

Pre-procedure1

1. Disconnect the TCM connector.

   Procedure1

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   C25-4 (SL8+) - C25-21 (SLG1)	20°C (68°F)	5.0 to 5.6 Ω

   Result

   Proceed to
   OK
   NG

   Post-procedure1

3. None.

Result: 

OK 

REPLACE TCM. Refer to  REMOVAL [09/2023 - ] 

Result: 

NG 

See step  3

Pre-procedure1

1. Disconnect the transmission wire connector.
2. Disconnect the TCM connector.

   Procedure1

3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   C65-19 (SL8+) - C25-4 (SL8+)	Always	Below 1 Ω
   C65-10 (SLG1) - C25-21 (SLG1)	Always	Below 1 Ω
   C65-19 (SL8+) or C25-4 (SL8+) - Body ground and other terminals	Always	10 kΩ or higher
   C65-10 (SLG1) or C25-21 (SLG1) - Body ground and other terminals	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

   Post-procedure1

4. None.

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  4

Refer to INSPECTION [09/2023 - ]

Result

Result: 

OK 

REPAIR OR REPLACE TRANSMISSION WIRE. Refer to  REMOVAL [09/2023 - ] 

Result: 

NG 

REPLACE SOLENOID (SL8) VALVE (TRANSMISSION VALVE BODY ASSEMBLY). Refer to  REMOVAL [09/2023 - ]