Typical Enabling Conditions
WARNING: This page is about a different car, the 2024 Lexus TX 500h. However, it is still accessible from the selected car via links, so may be relevant.
| DS_active_wake* | TRUE |
| Pressure control solenoid driver error (P1700) | Not detected |
| Either condition is met | (a) or (b) |
| (a) Pressure control solenoid driver status BATT short | Not Occurred |
| (b) Solenoid current | Below 0.02 A |
| Solenoid current cut status | Not cut |
| Time after solenoid current cut status cut to not cut | 0.02 seconds or more |
| Solenoid current cut status from HSDNM | Not cut |
| Time after solenoid current cut status from HSDNM cut to not cut | 0.02 seconds or more |
HINT:
*: DS_active_wake
| Following condition is met | 0.5 seconds or more |
| Auxiliary battery voltage | 9.5 V or higher |