LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> TX 350 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Hybrid Transaxle System (Pc60) - Diagnostic Codes (2 Of 4)) >> Hybrid Transaxle System >> DTC P08DE-7F: Shift Solenoid "L" Performance/Stuck Off Actuator Stuck Off [09/2023 - ] >> Description

DTC P08DE-7F: Shift Solenoid "L" Performance/Stuck Off Actuator Stuck Off [09/2023 - ]: Description

WARNING: This page is about a different car, the 2024 Lexus TX 500h. However, it is still accessible from the selected car via links, so may be relevant.

The TCM performs fail-safe control through the use of ON-OFF combinations of the solenoid (SC4 and SR) valve.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL DTC Output from Priority Note
P08DE-7F Shift Solenoid "L" Performance/Stuck Off Actuator Stuck Off Either condition is met: (2-trip detection logic)
  • When the engine is started, the integrated value of the oil pressure sensor value minus the WSC oil pressure command value is 215600 kPa (2198.5 kgf/cm2 , 31262 psi) or higher
  • When the engine is not started, the integrated value of the oil pressure sensor value minus the WSC oil pressure command value is 431200 kPa (4397 kgf/cm2 , 62524 psi) or higher
  • When the TCM commands SC4 ON, it is detected 3 times that the oil pressure sensor value is higher than the line pressure command value by 490 kPa (5.0 kgf/cm2 , 71 psi) or higher for 1 second
  • Transmission valve body assembly
  • Transaxle assembly with motor
Comes on Transmission B SAE: P08DF
DTC DETECTION CONDITION PATTERNS

  Vehicle Condition
Pattern 1 Pattern 2 Pattern 3
Diagnostic Condition Engine is started ◦ - -
Engine is not started - ◦ -
TCM commands SC4 ON - - ◦
Malfunction Condition The integrated value of the oil pressure sensor value minus the WSC oil pressure command value is 215600 kPa (2198.5 kgf/cm2 , 31262 psi) or higher ◦ - -
The integrated value of the oil pressure sensor value minus the WSC oil pressure command value is 431200 kPa (4397 kgf/cm2 , 62524 psi) or higher - ◦ -
Oil pressure sensor value is higher than the line pressure command value by 490 kPa (5.0 kgf/cm2 , 71 psi) or higher - - ◦
Duration - - 3 times for 1 second or more
Detection Logic 2-trip detection logic 2-trip detection logic 2-trip detection logic

HINT: 

This DTC is stored when any of the above detection patterns are met.