Utility [09/2023 - ]
WARNING: This page is about a different car, the 2024 Lexus TX 500h. However, it is still accessible from the selected car via links, so may be relevant.
- ALL READINESS
HINT:
- With "All Readiness", you can check whether or not the DTC judgment has been completed by using the GTS.
- Check "All Readiness" after simulating malfunction symptoms or for validation after finishing repairs.
- Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Powertrain > Rear Motor Generator > Clear DTCs
- Turn the ignition switch off and wait for at least 2 minutes.
- Turn the ignition switch to ON.
- Perform the DTC confirmation driving pattern to run the DTC judgment.
- Enter the following menus: Powertrain / Rear Motor Generator / Utility / All Readiness.
Powertrain > Rear Motor Generator > Utility
Tester Display All Readiness - Input the DTCs to be confirmed.
- Check the DTC judgment result.
GTS Display Description NORMAL - DTC judgment completed
- System normal
ABNORMAL - DTC judgment completed
- System abnormal
INCOMPLETE - DTC judgment not completed
- Perform the driving pattern
If the judgment result shows INCOMPLETE, perform the DTC confirmation driving pattern again.
- Turn the ignition switch off.
- CHECK FOR DIAGNOSIS RELATED INFORMATION
- Connect the GTS to the DLC3.
- Turn the ignition switch to ON.
- Turn the GTS on.
- Enter the following menus: Powertrain / Rear Motor Generator / Utility / Diagnosis Related Information.
Powertrain > Rear Motor Generator > Utility
Tester Display Diagnosis Related Information - Check the diagnosis related information and freeze frame data, and then write them down.
- RESOLVER LEARNING
Refer to the precautions before inspecting resolver learning.
Refer to UTILITY [09/2023 - ]