DTC P0914-2B: Gear Shift Position Circuit "A" Range/Performance Signal Cross Coupled [09/2023 - ]: Procedure
WARNING: This page is about a different car, the 2024 Lexus TX 500h. However, it is still accessible from the selected car via links, so may be relevant.
- READ VALUE USING GTS (ABSOLUTE ANGLE SENSOR VALUE)
Pre-procedure1
- Turn the ignition switch to ON.
- Read the Data List according to the display on the GTS.
Powertrain > Hybrid Control > Data List
Tester Display Absolute Angle Sensor Value 1 Absolute Angle Sensor Value 2 Result
Result Proceed to The difference between the value of Absolute Angle Sensor Value 1 and Absolute Angle Sensor Value 2 is 1.9 or less A None of the above conditions are met B
Post-procedure1
- Turn the ignition switch off.
Result:
B
REPLACE SHIFT ACTUATOR ECU (SHIFT CONTROL ACTUATOR ASSEMBLY). Refer to REMOVAL [09/2023 - ]
Result:
A
See step 2
- CLEAR DTC
Pre-procedure1
- Turn the ignition switch to ON.
Post-procedure1
- Turn the ignition switch off.
- Disconnect the GTS.
- Leave the vehicle as is for 60 seconds or more.NOTE:
- Do not connect the GTS.
- Do not depress the brake pedal.
- Do not open/close any of the doors.
Result:
NEXT
See step 3
- CHECK DTC OUTPUT (PERFORM A REPRODUCTION TEST)
Pre-procedure1
- Turn the ignition switch to ON and wait for 1 minute or more.
- Check for DTCs.
Powertrain > Hybrid Control > Trouble Codes
Result
Result Proceed to P0914-2B is not output A P0914-2B is output B
Post-procedure1
- Turn the ignition switch off.
Result:
A
END
Result:
B
REPLACE SHIFT ACTUATOR ECU (SHIFT CONTROL ACTUATOR ASSEMBLY). Refer to REMOVAL [09/2023 - ]