DTC P08A6-62: Gear Lever Position Sensor Signal Compare Failure [09/2023 - ]: Procedure

Pre-procedure1

1. Turn the ignition switch to ON.

   Procedure1

2. Using the GTS, perform a Health Check.
3. Check for DTCs.

   Result

   Proceed to
   NEXT

   Post-procedure1

4. Turn the ignition switch off.

Result: 

NEXT 

See step  2

Pre-procedure1

1. Turn the ignition switch to ON.

   Procedure1

2. Clear the DTCs.

   Powertrain > Hybrid Control > Clear DTCs 

   Result

   Proceed to
   NEXT

   Post-procedure1

3. Turn the ignition switch off.
4. Disconnect the GTS.
5. Leave the vehicle as is for 60 seconds or more.
   NOTE:

   • Do not connect the GTS.
   • Do not depress the brake pedal.
   • Do not open/close any of the doors.

Result: 

NEXT 

See step  3

Pre-procedure1

1. Turn the ignition switch to ON (READY).
2. Depress the brake pedal and slowly change the shift state from N to R to N to D to M to the home position.
3. Press the P position switch to change the shift state to P.
4. Turn all switches off and turn the ignition switch off.
5. Disconnect the GTS.
6. Wait for 5 minutes or more with the door lock locked.

   HINT: 

   • Once the door lock is locked, keep the electrical key transmitter sub-assembly (electrical key) 3 m (9.84 ft.) or more away from the vehicle.
   • Because the system will not sleep while any door and/or the hood is open, take steps such as securing the courtesy switch to make the system recognize the doors and hood as closed when carrying out the operation.
   • If the vehicle is equipped with a power back door, the system will not sleep if the back door is not closed. Ensure that the back door is closed before carrying out the operation.
7. Turn the ignition switch to ON (READY).
8. Depress the brake pedal and slowly change the shift state from N to R to N to D to M to the home position.
9. Press the P position switch to change the shift state to P.

   Procedure1

10. Check for DTCs.

    Powertrain > Hybrid Control > Trouble Codes 

    Result

    Result	Proceed to
    Only P08A6-62 is output	A
    P08A6-62 and other DTCs are output	B
    DTCs are not output	C

    Post-procedure1

11. Turn the ignition switch off.

Result: 

A 

REPLACE SHIFT CONTROL ECU (TRANSMISSION FLOOR SHIFT ASSEMBLY). Refer to  REMOVAL [09/2023 - ] 

Result: 

B 

GO TO DTC CHART. Refer To  DIAGNOSTIC TROUBLE CODE CHART [09/2023 - ] 

Result: 

C 

CHECK FOR INTERMITTENT PROBLEMS 

Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2023 - ]

Refer to ELECTRONIC CIRCUIT INSPECTION PROCEDURE [09/2023 - ]