Caution / Notice / Hint

WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.

COMPONENTS (REASSEMBLY)

Fig 1: Cylinder Block Reassembly Components With Torque Specifications (1 Of 2)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Procedure		Part Name Code
1	STRAIGHT PIN	-	See step 1	-	-
2	STUD BOLT	-	See step 2	-	-

N.m (kgf/cm, ft.lbf): Specified torque

•

Non-reusable part

Fig 2: Cylinder Block Reassembly Components With Torque Specifications (2 Of 2)

Procedure		Part Name Code
3	CONNECTING ROD SMALL END BUSH	-	See step 3	-	-
4	NO. 1 OIL NOZZLE SUB-ASSEMBLY	15708	See step 4	-	-
5	PISTON PIN	-	See step 5	-	-
6	PISTON RING SET	13011	See step 6	-	-
7	CRANKSHAFT BEARING	11711	See step 7	-	-
8	CRANKSHAFT THRUST WASHER SET	11011	See step 8	-	-
9	CRANKSHAFT	13411	See step 9	-	-
10	CONNECTING ROD BEARING	13041	See step 10	-	-
11	PISTON WITH CONNECTING ROD	-	See step 11	-	-

*1	CONNECTING ROD	*2	CONNECTING ROD BOLT
*3	CYLINDER BLOCK SUB-ASSEMBLY	*4	CRANKSHAFT BEARING CAP SET BOLT
*5	SEAL WASHER	*6	CONNECTING ROD BEARING CAP
*7	CRANKSHAFT BEARING CAP	-	-
	Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf)		N.m (kgf/cm, ft.lbf): Specified torque
•	Non-reusable part	-	-
*T1	1st: 24.5 (250, 18) 2nd: Turn 90°	*T2	1st: 61 (622, 45) 2nd: Turn 90°