Confirmation Driving Pattern

HINT: 

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Refer to UTILITY [12/2023 - ]

U0100-87, U0293-87:

HINT: 

When clearing the permanent DTCs, refer to the "CLEAR PERMANENT DTC" procedure.

Refer to DTC CHECK / CLEAR [12/2023 - ]

1. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
2. Turn the ignition switch off and wait for 2 minutes or more.
3. With ignition switch ON and wait for 2 minutes or more. [*1]

   HINT: 

   [*1]: Normal judgment procedure.

   The normal judgment procedure is used to complete DTC judgment and also used when clearing permanent DTCs.

4. Enter the following menus: Powertrain / Plug-in Control / Utility / All Readiness.
5. Check the DTC judgment result.

   HINT: 

   • If the judgment result shows NORMAL, the system is normal.
   • If the judgment result shows ABNORMAL, the system has a malfunction.
   • If the judgment result shows INCOMPLETE, perform the normal judgment procedure again.

U0155-87:

1. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
2. Turn the ignition switch off and wait for 2 minutes or more.
3. With ignition switch to ON and wait for 2 minutes or more.
4. Enter the following menus: Powertrain / Plug-in Control / Utility / All Readiness.
5. Check the DTC judgment result.

   HINT: 

   • If the judgment result shows NORMAL, the system is normal.
   • If the judgment result shows ABNORMAL, the system has a malfunction.
   • If the judgment result shows INCOMPLETE, perform driving pattern again.