Confirmation Driving Pattern

WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Refer to UTILITY [12/2023 - ]

Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Enter the following menus: Powertrain / Hybrid Control / Data List.
Check that "Hybrid/EV Battery SOC" shows 70% or less.
Turn the ignition switch off and wait for 2 minutes or more.
Connect the electric vehicle charger cable assembly, and plug-in charge the vehicle for 30 minutes or more.
HINT:

If "PFC Boosting Circuit Temperature" or "DC/DC Converter Temperature (for Charging)" becomes 55°C (131°F) or more, the cooling fun rotates and a malfunction could be detected.
Disconnect the electric vehicle charger cable assembly and wait for 10 seconds or more.
Enter the following menus: Powertrain / Plug-in Control / Utility / All Readiness.
Check the DTC judgment result.
HINT:
- If the judgment result shows NORMAL, the system is normal.
- If the judgment result shows ABNORMAL, the system has a malfunction.
- If the judgment result shows INCOMPLETE, perform driving pattern again.