Charging Indicator Circuit [12/2023 - ]: Procedure

1. Enter the following menus: Health Check.
2. Check DTCs.

   Result

   Result	Proceed to
   No DTCs are output	A
   DTCs are output	B

3. Turn the ignition switch off.

Result: 

B 

GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [12/2023 - ] 

Result: 

A 

See step  2

1. Check for Vehicle Control History (RoB).

   Powertrain > Plug-in Control > Utility 

   Tester Display
   Vehicle Control History (RoB)

   Powertrain > Hybrid Control > Utility 

   Tester Display
   Vehicle Control History (RoB)

   Result

   Result	Proceed to
   Vehicle Control History (RoB) not stored	A
   Vehicle Control History (RoB) stored	B

2. Turn the ignition switch off.

Result: 

B 

GO TO VEHICLE CONTROL HISTORY (ROB) 

• PLUG-IN CHARGE CONTROL SYSTEM

  Refer to VEHICLE CONTROL HISTORY (RoB) [12/2023 - ]

• HYBRID CONTROL SYSTEM

  Refer to VEHICLE CONTROL HISTORY (RoB) [12/2023 - ]

Result: 

A 

See step  3

1. Using the electric vehicle charger cable assembly, plug-in charge the vehicle.
2. Read the value displayed on the GTS.

   Powertrain > Plug-in Control > Data List 

   Tester Display
   Charging Indicator lighting Request

   Powertrain > Plug-in Control > Data List 

   Tester Display	Measurement Item	Range	Normal Condition
   Charging Indicator lighting Request	Charging indicator lighting request	ON or OFF	Charging indicator light illuminated: ON Charging indicator light not illuminated: OFF

   Result

   Result	Proceed to
   The display changes according to the charging indicator light condition	A
   The display does not change according to the charging indicator light condition	B

3. Disconnect the electric vehicle charger cable assembly.
4. Turn the ignition switch off.

Result: 

A 

GO TO AC CHARGING DOES NOT START (PLUG-IN CHARGE CONTROL SYSTEM). Refer to  AC Charging Does not Start [12/2023 - ]  

Result: 

B 

See step  4

Refer to INSPECTION [12/2023 - ]

Result

Result: 

NG 

REPLACE EV CHARGER LID INDICATOR (CHARGING INDICATOR). Refer to  REMOVAL [12/2023 - ] 

Result: 

OK 

See step  5

1. Check that the service plug grip is not installed.
   NOTE:

   After removing the service plug grip, do not turn the ignition switch to ON (READY), unless instructed by the service information because this may cause a malfunction.

2. Disconnect the J84 electric vehicle charger assembly connector.
3. Disconnect the I57 EV charger lid indicator (charging indicator) connector.
4. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I57-1 (PIL) - J84-12 (PIL)	Ignition switch off	Below 1 Ω
   I57-1 (PIL) or J84-12 (PIL) - Body ground and other terminals	Ignition switch off	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

5. Reconnect the EV charger lid indicator (charging indicator) connector.
6. Reconnect the electric vehicle charger assembly connector.

Result: 

OK 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [12/2023 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR